Clay Liner Removal
| Sometimes old clay liners need removing from properties. They may not have been correectly installed initially, are blocked or partially collapsed or covered in tar that cannot be otherwise removed. Additionally sometimes the installation of a flexi liner for a stove is not possible without full or partial removal of the liner. This is usually identified by a HETAS installer. |
| Previously such work was not possible without very invasive and expensive structural work to provide access to the liner through the fabric of the building. We now operate equipment that can break the liner up in situ without recourse to major works. |
| We have successsfully removed full length clay liners from buildings in a much more cost effective way than previously possible. |
| It is likely that one or more site visits are necessary, with some testing, to establish is the clay liner is suitable for removal. Please make early contact if you are considering this work to allow sufficient time to be booked for this assessment work. Typical results can be seen below. |
 |
| Test removal of section of 8" clay liner |
